Chapter 2 Setting The Lt140; Settings For Sas Connections; Settings For Fibre Channel Connections; Setting The Link Speed - Fujitsu ETERNUS LT140 User Manual

Chapter 2
Setting the LT140
This chapter describes the necessary LT140 settings to use the LT140 from backup software.
Use the operator panel to perform the settings that are described below. For more details about how to use
the operator panel, refer to "FUJITSU Storage ETERNUS LT140 Tape Library User's Guide -Panel Operation-" and
"FUJITSU Storage ETERNUS LT140 Tape Library User's Guide -Installation & Operation-".
Check whether the LT140 supports your server environment by referring to our web site
(https://www.fujitsu.com/global/products/computing/storage/tape/).
2.1

Settings for SAS Connections

No setting is required for SAS models.
2.2

Settings for Fibre Channel Connections

This section explains how to set up the drives for Fibre Channel connections.
2.2.1

Setting the Link Speed

For the link speed of a drive path, 2Gbit/s, 4Gbit/s, or 8Gbit/s can be selected.
For more details about the settings, refer to "FUJITSU Storage ETERNUS LT140 Tape Library User's Guide
-Panel Operation-".
Although the "Auto" setting can be selected, select one of the fixed values according to the FC switch or the
HBA of the connection destination that is used.
FUJITSU Storage ETERNUS LT140 Tape Library User's Guide -Server Connection-
22
Copyright 2019 FUJITSU LIMITED P3AG-3752-03ENZ0