Table of Contents
Advertisement
INS TA L LAT IO N
W A R N I N G !
A
Position panel with plug
connectors facing down.
Mount control panel with
1/4-20 fasteners, one in
each corner of the panel.
A
C
Do not use extension cord with fan.
Do not remove covers while power is on.
Do not use improper voltage source.
11
4
CONTROL PANEL
Before completing the mechanical installation, ensure breaker is off and all Lockout/Tagout
procedures are in place. The electrical receptacle for the panel should be installed prior to panel
installation. For a chart of receptacles, refer to page 15.
If the retention cable is not installed, the warranty will be voided.
B
Connect VFD cable from
fan to control panel.
Twist connector to lock
in place. Secure excess
cable to ceiling or beam.
B
D
CAUTION: DO NOT CONNECT POWER UNTIL
MECHANICAL INSTALLATION IS COMPLETE.
C
Connect the
communication
cable to one of the comm
terminals and run down
to user touchscreen
location.
D
Connect electrical plug to
panel. Twist connector to
lock into place.
NOTE
Twist Lock will act
as a disconnect.
TIP
For detailed
E-Stop (Fire Relay)
wiring, see Page 17
Advertisement
Table of Contents
