Preparing The Remote Control - Hunter Kaplan 59322 Installation Manual

1886
The remote control is already
paired for use.
Battery Door
To access the battery
compartment, remove
the battery door to the
transmitter assembly.
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
9
Ceiling Bracket Downrod

Preparing the Remote Control

Install two AAA batteries, found in the
remote control hardware bag, into the
transmitter. Clean the battery contacts
prior to installing the batteries. Please
contact your local battery recycling center
for proper battery disposal information.
Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Hanging Fan Wiring
• Always purchase the correct size and grade of
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
• Ensure the batteries are installed correctly with
• Remove batteries from equipment which is not to
• Remove used batteries promptly.
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Canopy Blades
NOTICE
battery most suitable for the intended use.
device prior to battery installation.
regard to polarity (+ and -).
be used for an extended period of time.
Slide the cradle onto
the mounted bracket.
Light Bulbs/Glass Remote Remote Cradle