Remote Control - Hunter M3627-01 Manual

Remote Control

Battery
Door
To access the battery compartment, remove
the battery door from the transmitter
assembly. The battery should be installed
with the positive (+) side up. Replace with a
CR2032 battery when necessary.
ON
17
M3627-01 • 06/05/17 • © 2017 Hunter Fan Company
www.HunterFan.com
The remote transmitter is already paired to the
receiver and ready to use.
Note: If your need to pair your remote, remove the battery
door. Cycle power to the fan by turning power off and back on
at the wall switch (or circuit breaker if necessary). Within three
minutes, press the pair button on the remote. If pairing was
successful, a single beep will sound. If three beeps sound, the
remote was unpaired. Re-pair using the steps above.
To prevent faulty operation, please disconnect power from
all other ceiling fans within range while pairing.
1.888.830.1326