Preparing The Remote Control - Hunter Turlington LED Installation Manual

1886
The remote control is already
paired for use.
Battery Door
Battery
Screw
9
Ceiling Bracket Downrod
Installing the Pull Chains
Feed the pull chains from the fan switch
and the light switch down through the
holes in the upper switch housing as
shown. Attach the pull chain pendants
to the light and fan pull chains.
Repeat x2

Preparing the Remote Control

To access the battery compartment, remove the small
Phillips head screw that secures the battery door to
the transmitter assembly. Install one 3-Volt, CR2032
battery, found in the remote control hardware bag,
into the transmitter. Clean the battery contacts and
also those of the device prior to battery installation.
The battery should be installed with the positive (+)
side up. Please contact your local battery recycling
center for proper battery disposal information.
Hanging Fan Wiring
The fan pull chain controls
the speed: from high to off.
• Always purchase the correct size and grade of
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
• Ensure the batteries are installed correctly with
• Remove batteries from equipment which is not to
• Remove used batteries promptly.
Canopy Blades
The light pull chain controls
the light fixture: on and off.
NOTICE
battery most suitable for the intended use.
device prior to battery installation.
regard to polarity (+ and -).
be used for an extended period of time.
Light Bulbs/Glass Remote Remote Cradle