Selecting The Point Type - Bosch SE3000 Series Technical Reference Manual

Security Escort
Figure 7.6: Example of Select point desired dialog showing "Receivers Only"
To configure the new SE receiver, click on the SE receiver's corresponding Point Number in
the grid. This closes the window automatically and populates the number into the Point
Number field on the Edit Transponder's Database Record dialog.
Alternatively, if you do not wish to use the grid, the [+] and [-] buttons, just below the Point
Number lets you advance or retreat the device selection quickly by one location. This is useful
when a task requires proceeding from device to device, as during system setup or check out.
The [?] button is used to display all devices to facilitate quick selection of a particular device.
It is most useful when diagnosing a problem with a particular device.
Once the point you wish to configure is reflected in the Point Number field, you may proceed
to enter the necessary information.
7.9.2

Selecting the Point Type

The Point Type drop-down list indicates the type of device that can be assigned to the
selected Point Number. Click the drop-down list to change it to your desired Point Type.
The valid Point Type for SE coordinator are "SE receiver", "Virtual" (receiver), and "None".
The default Point Type is "None". Select the Point Type device accordingly when there is a
physical device connected at this bus location.
Selecting "SE receiver" as the Point Type
Selecting "SE receiver" as the Point Type will populate the dialog window as shown below.
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
Technical Reference Manual
71
2018.03 | SE3v1.0 | DOC