Table of Contents
Advertisement
62
en | Central Console, computer setup and programming
Element
Modem reset
[Save]
[Cancel]
7.4
Transponder database
The Transponder database is established at system set-up and contains all necessary
configuration data for each SE coordinator and SE receiver. It describes the basic structure of
the installation, including all device names, locations, types, addresses, etc. This information
is used by the Central Console to generate "Alarm" and "Test" displays on the console.
Start by filling out the setup of the SE coordinator and it's SE receivers in the information
sheet. Based on the information sheet, key in all the configuration details accordingly into the
database using the Transponder database dialog.
2018.03 | SE3v1.0 | DOC
Usage/Description
This is the reset string transmitted to the modem. Normally, this
setting does not need to change. To allow changes to this string,
hold down the <Shift>+ <Ctrl> keys when this dialog is first
opened. This string is specific to each modem model. The default
string should work with most modems.
Save the changes and close the dialog window.
Cancel the changes and close the dialog window..
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
