Table of Contents
Advertisement
Security Escort
6
Installation options
6.1
Demo installations
When the software is used for demo purposes, it is limited to 10 records in the Subscriber
Database, 1 transponder and/or 1 SE coordinator in the Transponder Database and total 64
receivers or 15 SE receivers. If these limitations are observed, the system can be used with
full functionality for demo purposes. Refer to the Installing the Security Escort software
section to install the software.
Components
Subscriber Database
Transponder Database
Workstations
Tab. 6.5: Demo Limitations
After the software has been installed, do not run it. Double-click the HDD32.EXE file in the
Security Escort directory ("C:\ESCORT"). This will install the driver for the software key. This
is required even for demo installations that will not have the software key. If the HDD32.EXE
installer is not run before the Security Escort software is run the first time, the Security Escort
software will stop with an error and HDD32.EXE will automatically run. The demo installation
is complete at this point and you do not have to refer to the rest of this document.
In demo mode, communication is limited to 1 SE coordinators even if the Transponder
database has more than 1 SE coordinators in it for diagnostic purposes. The SE coordinator
selected in the Transponder current status or Transponder communications dialog will be
the SE coordinator that can be communicated with. The SE coordinator can be reselected at
any time to change the current SE coordinator in communication.
All tests, supervisions and maintenance alarms will function normally; however only subscriber
alarms that contain reports from 15 SE receivers will function. If an alarm also includes other
SE receivers reporting, that alarm will be ignored. Therefore, actual Security Escort operation
can be demonstrated using up to 15 SE receivers.
A demo system can be used to directly connect to SE coordinators using the actual
Transponder database from the system to perform all functions except subscriber alarms.
This is desirable to allow a laptop to be plugged directly into an SE coordinator to diagnose
problems. In both of these modes the Subscriber database must have 10 or less subscribers.
6.2
Non-network installations
If this system is not using the network to connect master, slave and workstation computers,
refer to the Security Escort software installation section of this document to install the
software. After the software has been installed, do not run it. Plug the software key into the
USB port on the computer and double-click the HDD32.EXE file in the Security Escort
directory ("C:\ESCORT"). This will install the driver for the software key.
Robert Bosch (SEA) Pte Ltd
Object
Limitations
Subscribers
10 records
Transponder
1 record
SE coordinator
1 record
Receivers
64 records
- only 24 on bus 0 to 2 have full functionalities
SE receivers
15 records
8
Technical Reference Manual
Installation options | en
45
2018.03 | SE3v1.0 | DOC
Advertisement
Table of Contents
