JBL ES250PW Service Manual page 8

ES250PW
SYSTEM CONNECTIONS
Choose either Wireless or Wired connection, then follow the appropriate instructions.
WIRELESS
Connecting the Subwoofer for Wireless Applications
DC18V
1. Connect a subwoofer cable from the subwoofer or LFE output of your receiver
C
to the Sub In on the transmitter.
2. Plug the transmitter module's power supply into the wall outlet, and connect
the included power cord to the transmitter
‚
Antenna is extended upward.
3. Set the ID code on the transmitter and subwoofer (
same position, as described on page 6. When connected properly, the LED
on the top of the subwoofer will be orange.
4. Set the Low-Pass Selector
NOTES:
You may also connect a variable full-range output from an A/V receiver or
processor, such as a preamp output or second-room output. In this case,
set the Low-Pass Selector
adjustment as described on page 6.
Some receivers have two subwoofer outputs. In that case, use either connector.
Downloaded from www.Manualslib.com
ID
CODE
Sub In
1 2 3 4
A
. Make sure the Transmitter
B
∞
and
¢
to the "Off" position.
¢
to the "On" position and set the crossover
manuals search engine
WIRED
Connecting the Subwoofer for Wired Applications
If you have a Dolby
effects (LFE) or subwoofer output:
Wireless
ID Code
Sub In
) to the
If your receiver/processor does not contain a Dolby Digital or DTS processor
but has subwoofer outputs:
NOTE: If your receiver/processor has only one sub out, you may use
either the L or R input.
7
® Digital or DTS ® receiver/processor with a low-frequency
Level
Crossover
[Hz]
O O ff ff O O n n
Low-Pass
Low-Pass
L R LFE
Line In
Level
Wireless
O ff
ID Code
Low-Pass
L R LFE
Sub In
Crossover
[Hz]
O n
Line In
5