JBL ES250PW Service Manual page 37

ES250PW
3. PIN DESCRIPTION
Serial Clock / De-emphasis SCLK/DEM1
Left/Right Clock
Digital Interface Format
Digital Interface Format
RST
SDATA
SCLK
Downloaded from www.Manualslib.com
Reset RST
Serial Data SDATA
LRCK
Master Clock MCLK
DIF1
DIF0
De-emphasis DEM0
1 Reset ( Input ) - The device enters a low power mode and all internal state machines are reset to
the default settings when low. RST should be held low during power-up until the power supply,
master and left/right clocks are stable.
2 Serial Audio Data ( Input ) - Two's complement MSB-first serial data is input on this pin. The
data is clocked into SDATA via the serial clock and the channel is determined by the Left/Right
clock. The required relationship between the Left/Right clock, serial clock and serial data is
defined by the DIF1-0 pins. The options are detailed in Figures 16-19.
3 Serial Clock ( Input ) - Clocks the individual bits of the serial data into the SDATA pin. The
required relationship between the Left/Right clock, serial clock and serial data is defined by the
DIF1-0 pins. The options are detailed in Figures 16-19.
The CS4340 supports both internal and external serial clock generation modes. Internal SCLK
mode is used to gain access to extra de-emphasis modes.
Internal Serial Clock Mode - In the Internal Serial Clock Mode, the serial clock is internally
derived and synchronous with the master clock and left/right clock. The SCLK/LRCK frequency
ratio is either 32, 48, or 64 depending upon the DIF1-0 pins as shown in Figures 16-19. Opera-
tion in this mode is identical to operation with an external serial clock synchronized with LRCK.
External Serial Clock Mode - The CS4340 will enter the External Serial Clock Mode whenever
16 low to high transitions are detected on the SCLK pin during any phase of the LRCK period.
The device will revert to Internal Serial Clock Mode if no low to high transitions are detected on
the SCLK pin for 2 consecutive periods of LRCK.
manuals search engine
MUTEC
1 16
AOUTL
2 15
VA
3 14
AGND
4 13
AOUTR
5 12
REF_GND Reference Ground
6 11
VQ
7 10
FILT+
8 9
36
CS4340
Mute Control
Left Analog Output
Analog Power
Analog Ground
Right Analog Output
Quiescent Voltage
Positive Voltage Reference