JBL ES250PW Service Manual page 32

ES250PW
Pin Description
PIN NAME
1 SW
2 BST
3 R
CL
4 RTN
5 FB
6 R /SD
ON
7 V
CC
8 V
IN
Typical Application Circuit and Block Diagram
Downloaded from www.Manualslib.com
DESCRIPTION
Switching Node
Boost Pin (Boot–strap capacitor input)
Current Limit OFF time set pin
-5
Toff = 10 / (0.285 + (FB / 6.35 x 10
Ground pin
Feedback input from Regulated Output
On time set pin
-10
Ton = 1.25 x 10 R / V
ON IN
Output from the internal high voltage series pass
regulator. Regulated at 7.0V.
Input voltage
manuals search engine
APPLICATION INFORMATION
Power switching node. Connect to the output
inductor, re-circulating diode, and bootstrap
capacitor.
An external capacitor is required between the BST
and the SW pins. A 0.01µF ceramic capacitor is
recommended. An internal diode charges the
capacitor from V
A resistor between this pin and RTN sets the
− 6
x R )) off-time when current limit is detected. The off-time
CL
is preset to 35µs if FB = 0V.
Ground for the entire circuit.
This pin is connected to the inverting input of the
internal regulation comparator. The regulation
threshold is 2.5V.
A resistor between this pin and V
on time as a function of V
recommended on time is 400ns at the maximum
input voltage. This pin can be used for remote
shutdown.
If an auxiliary voltage is available to raise the
voltage on this pin, above the regulation setpoint
(7V), the internal series pass regulator will
shutdown, reducing the IC power dissipation. Do not
exceed 14V. This voltage provides gate drive power
for the internal Buck switch. An internal diode is
provided between this pin and the BST pin. A local
0.1µF decoupling capacitor is recommended. Series
pass regulator is current limited to 10mA.
Recommended operating range: 9.5V to 95V.
31
F.
.
CC
sets the switch
IN
. The minimum
IN
20097901