Genie GR-12 Service Manual page 73

November 2005
REV A
How to Remove the
Hydraulic Pump
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation. Refer to
Section Two, Hydraulic Hose and
Fitting Torque Specifications.
1 Tag, disconnect and plug the hydraulic supply
hard line at the pump. Cap the fitting on the
pump.
2 Tag, disconnect and plug the high pressure
hose at the pump. Cap the fitting on the pump.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
3 Remove the pump mounting bolts. Carefully
remove the pump.
Tip-over hazard. After replacing
the hydraulic pump, it is critical to
return the function speed settings
to original factory specifications.
Failure to restore the machine to
original factory specifications
could cause the machine to tip
over, resulting in death or serious
injury.
Part No. 84700 GR-12 • GR-15 • GR-20
Section 4 • Repair Procedures
HYDRAULIC PUMP
4 - 25