Vmebus Connectors (P1 & P2) (Sbc Mode) - Motorola MVME5500 Installation And Use Manual

Table 5-16. VME Connector (P2) Pin Assignments (PMC Mode)
Pin ROW Z ROW A
29 PMC2_44 PMC1_58
(J24-44) (J14-58)
30 GND PMC1_60
(J14-60)
31 PMC2_46 PMC1_62
(J24-46) (J14-62)
32 GND PMC1_64
(J14-64)
VMEbus Connectors (P1 & P2) (SBC Mode)
The VME P1 and P2 connectors are 160-pin DINs. The P1 connector
provides power and VME signals for 24-bit address and 16-bit data. The
pin assignments for the P1 connector are specified by the VME64
Extension Standard (refer to
link to this specification).
Row B of the P2 connector provides power to the MVME5500 and to the
upper eight VMEbus address lines, and additional 16 VMEbus data lines.
The pin assignments for the P2 connector are as follows:
Warning When J28 is configured for IPMC mode, –12V is supplied to P2 pin A30.
!
If there is an incompatible board plugged into this P2 slot, damage may
occur.
Warning
When J32 is configured for IPMC mode, +12V is supplied to P2 pin C7. If
there is an incompatible board plugged into this P2 slot, damage may
occur.
http://www.motorola.com/computer/literature
VMEbus Connectors (P1 & P2) (SBC Mode)
ROW B ROW C
VD30 PMC1_57 (J14-57)
VD31 PMC1_59 (J14-59)
GND PMC1_61 (J14-61)
+5V PMC1_63 (J14-63)
Appendix D, Related
ROW D
PMC2_43 (J24-43)
PMC2_45 (J24-45)
GND
+5V
Documentation, for the
5-25
5