Introduction - Motorola MVME5500 Installation And Use Manual

Introduction

This chapter provides pin assignments for various headers and connectors
on the MMVE5500 single-board computer.
The following headers are described in this chapter:
5Pin Assignments
Asynchronous Serial Port Connector (J1) on page 5-2
Ethernet Connectors (J2) on page 5-3
IPMC Connector (J3) on page 5-3
PCI/PMC Expansion Connector (J4) on page 5-5
CPU COP Connector (J5) on page 5-8
PMC 1 Interface Connectors (J11, J12, J13, J14) on page 5-8
Boundary Scan Connector (J18) on page 5-15
PMC 2 Interface Connectors (J21, J22, J23, J24) on page 5-16
Asynchronous Serial Port (COM2) Planar Connector (J33) on
page 5-22
VMEbus Connectors (P1 & P2) (PMC Mode) on page 5-22
VMEbus Connectors (P1 & P2) (SBC Mode) on page 5-25
Memory Expansion Connector (P4) on page 5-29
Ethernet 2, PMC/SBC Mode, and P2 I/O Selection Headers (J6,
J7, J28, J32, J34, J97 – J110) on page 5-33
Flash Boot Bank Select Header (J8) on page 5-40
Flash 0 Programming Enable Header (J9) on page 5-40
Safe Start ENV Header (J10) on page 5-41
Flash 0 Block Write Protect Header (J15) on page 5-41
SROM Initialization Enable Header (J17) on page 5-42
5
5-1