Connection To Peripherals; Table 1-3. Mvme5500 Connectors - Motorola MVME5500 Installation And Use Manual

Hardware Preparation and Installation
1

Connection to Peripherals

1-18
When the MVME5500 is installed in a chassis, you are ready to connect
peripherals and apply power to the board.
Figure 1-1 on page 1-7
Table 1-3 lists them for you. Refer to
pin assignments of the connectors listed below.
Note
If a PMC module is plugged into PMC slot 1, the memory
mezzanine card cannot be used because the PMC module covers
the memory mezzanine connector.

Table 1-3. MVME5500 Connectors

Connector
J1
J2
J3
J4
J5
J11, J12, J13, J14
J18
J21, J22, J23, J24
J33
P1, P2
P4
shows the locations of the various connectors while
Chapter 5, Pin Assignments
Function
COM1 front-panel connector
Dual 1000/100/10BaseT front-panel connectors
IPMC connector
PCI/PMC expansion connector
CPU COP connector
PMC 1 connectors
Boundary scan connector
PMC 2 connectors
COM2 planar connector
VME rear panel connectors
Memory expansion connector
for the
Literature Center Web Site