Connection To Peripherals; Completing The Installation; Table 1-5. Mvme6100 Connectors - Motorola MVME6100 Installation And User Manual

Connection to Peripherals

When the MVME6100 is installed in a chassis, you are ready to connect peripherals and apply
power to the board.
Figure 1-1 on page 6
for you. Refer to
below.

Table 1-5. MVME6100 Connectors

Connector
J3
J4
J9, J93
J11, J12, J13, J14
J19
J21, J22, J23, J24
J29
P1, P2

Completing the Installation

Verify that hardware is installed and the power/peripheral cables connected are appropriate for
your system configuration.
Replace the chassis or system cover, reconnect the system to the AC or DC power source, and
turn the equipment power on.
shows the locations of the various connectors while
Chapter 5, Pin Assignments
Function
IPMC761/712 connector
PMC expansion connector
Gigabit Ethernet connectors
PCI mezzanine card (PMC) slot 1 connector
COM1 connector
PCI mezzanine card (PMC) slot 2 connector
COM2 planar connector
VME rear panel connectors
Chapter 1 Hardware Preparation and Installation
for the pin assignments of the connectors listed
MVME6100 Installation and Use (V6100A/IH2)
Table 1-5 lists them
11