Table of Contents
Advertisement
Using the Front Panel for Operations
8
Select the HDD to be removed with the arrow buttons (up
or down) and then press the [SET] button.
9
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
The HDD stop process begins and the HDD status indicator
on the extension unit blinks orange.
The HDD status indicator goes out once the HDD stop
process is complete.
•
If you stop the HDD during recording, recording switches
to another HDD. Images are not recorded for a few
seconds while recording switches. If another HDD is not
available, recording stops.
Press the [SET] button to return to the time display format
screen.
10
Remove the HDD unit from the extension unit.
(1)
Press the knob on the HDD unit.
(2)
Open the lever.
(3)
Remove the HDD unit.
Remove the HDD carefully so you do not bump it (be
careful not to drop it).
(1)
(2)
(2)
26
(3)
11
Close the front cover of the extension unit and lock it by
lightly pressing and turning the key to the left.
•
Keep the key in a safe place.
(1)
12
Check the disk information.
Check the following content related to the HDD under [Disk
information] on the settings menu of the network disk
recorder. Refer to the network disk recorder's Setup
Instructions (PDF file) for more information.
•
HDD capacity
•
HDD remaining capacity
•
Hour meter
•
Disk operation mode
•
Date range of video recorded on the HDD
Note:
•
You cannot remove HDDs by opening from the front panel
while operating in RAID5 or RAID6 mode.
•
Refer to page 30 when replacing HDD with errors.
(2)
Advertisement
Table of Contents
