Table of Contents
Advertisement
Using the cable clamp
Use the following procedure to attach the connection cables with the
cable clamp provided.
1
Attach the cable clamp (provided) to the rear panel of the
unit in the mounting holes and run the cables through
the clamp mechanism.
•
Lightly pull on the cable clamp to make sure it does not
come loose.
Mechanism of
cable clamp
2
Tighten the cable clamp's belt all the way.
3
Slide the mechanism of the cable clamp to lock the
connection cables' connectors in place.
•
Make sure that the connection cable cannot pull out.
Major Operating Controls and Their Functions
Note:
•
Diagram of cable clamp from above
(1) Clamp the connector's housing. If the belt is not completely
tight, the housing may come loose.
(2) Press up on the knob on top of the clamp when sliding the
cable clamp's clamp in the direction of the arrow (2) in the
diagram.
knob
(1)
(1)
(2)
Cable
Clamp
connector
13
Advertisement
Table of Contents
