Removing Hdds By Unit - Panasonic WJ-HDE400 Installation Manual

Removing HDDs by unit

All the HDDs in one extension unit can be removed at the same
time.
Also, refer to the network disk recorder's Installation Guide.
1
Insert the key (included) into the key hole and turn it
while pressing in gently to open the front cover.
(2)
The following operation is done on the network
disk recorder
2
Press the [USE] button for over 2 seconds.
A buzzer sounds.
Press the front panel buttons according to the directions on
the LCD.
3
Press the arrow buttons (up or down) on the front panel
until [HDD Operation] appears on the screen.
4
Press the [SET] button.
5
Press the arrow buttons (up or down) on the front panel
until [Remove EXT] appears on the screen.
6
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
7
Select the extension unit (EXTx) to be removed with the
arrow buttons (up or down) and then press the [SET]
button.
Using the Front Panel for Operations
8
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
The extension unit stop process begins and all the HDD
status indicator blink orange.
All the HDD status indicator go off once the stop process is
complete.
•
(1)
Press the [SET] button to return to the time display format
screen.
9
Make sure that all the HDD status indicator on the
extension unit are out, and then remove the HDD units.
(1)
(2)
(3)
(1)
10
Close the front cover of the extension unit and lock it by
lightly pressing and turning the key to the left.
•
If you stop the extension unit during recording, recording
switches to another HDD. Images are not recorded for a
few seconds while recording switches. If another device
with an HDD is not available, recording stops.
Press the knob on the HDD unit.
Open the lever.
Remove the HDD unit.
Remove the HDD carefully so you do not bump it (be
careful not to drop it).
(3)
(2)
(2)
Keep the key in a safe place.
(1)
(2)
27