Table of Contents
Advertisement
7
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
8
Select the extension unit's number where you installed
the HDD with the arrow buttons (up or down) and press
the [SET] button.
9
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
All the HDDs installed in the extension unit are recognized for
recording.
Press the [SET] button to return to the time display format
screen.
10
Close the front cover of the extension unit and lock it by
lightly pressing and turning the key to the left.
•
Keep the key in a safe place.
(1)
11
Check the disk information.
Check the following content related to the HDD under [Disk
information] on the settings menu of the network disk
recorder. Refer to the network disk recorder's Setup
Instructions (PDF file) for more information.
•
HDD capacity
•
HDD remaining capacity
•
Hour meter
•
Disk operation mode
•
Date range of video recorded on the HDD
Using the Front Panel for Operations
Removing HDDs
You can remove HDD units in the extension unit while it is in
operation.
Also, refer to the network disk recorder's Installation Guide.
1
Insert the key (included) into the key hole and turn it
while pressing in gently to open the front cover.
The following operation is done on the network
disk recorder
2
Press the [USE] button for over 2 seconds.
A buzzer sounds.
Press the front panel buttons according to the directions on
the LCD.
(2)
3
Press the arrow buttons (up or down) on the front panel
until [HDD Operation] appears on the screen.
4
Press the [SET] button.
5
Press the arrow buttons (up or down) on the front panel
until [Remove HDD] appears on the screen.
6
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
7
Select the HDD to be removed (Network Disk Recorder:
MAIN, Extension Unit (x): EXTx) with the arrow buttons
(up or down) and then press the [SET] button.
(2)
(1)
25
Advertisement
Table of Contents
