Adjusting The Picture Orientation; Primary Lens Adjustments; Focus; Zoom - Runco Video Xtreme VX-6000d Owner's Operating Manual

Installation
3.8
Adjusting the Picture
Orientation
3.9
Primary Lens
Adjustments

Focus

Zoom

By default, the VX-6000d is configured for a "floor/front" installation, in which the projector
is installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. Select an input OTHER THAN HDMI 1 or HDMI 2 on the DHD Controller.
2. Press MENU (on menu page 4) and enter the Service Menu passcode.
3. Select Service from the Main Menu.
4. Select Display Device from the Service Menu, then select Configure.
5. Press , then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the
installation method.
You must enter a passcode to access the Service menu.
Note
Lens zoom and focus are motorized adjustments that are adjustable from the remote
control. This allows you to adjust the focus and image size while at the screen for more
accurate results. The remote control has over 100 feet of range to the projector for long
throw distances.
The IR receiver for the lens motor assembly is
located on the projector behind the front Runco
logo cover. Rotate the logo cover 90 degrees as
shown to reveal the IR receiver opening.
1. With the IR receiver revealed on the front of the projector, go to the zoom/focus page
(5/7) of the remote control.
2. Point the remote directly at the projector for maximum range.
3. To focus the projected image, press and hold the FOCUS + or FOCUS - button.
To make the picture smaller (zoom out), press and hold the ZOOM - button. To enlarge
the picture (zoom in), press and hold the ZOOM + button.
40 Runco VX-6000d Owner's Operating Manual