Installation; Remote Control; Battery Installation; Notes On Remote Control Operation - Runco Video Xtreme VX-6000d Owner's Operating Manual

To install batteries in the remote control:
1. Remove the battery cover from
the back of the remote control.
2. Insert the batteries included
with the remote control. Ensure
that the polarities correctly
match the and
inside the battery compartment.
3. Replace the battery cover.
With the touch-screen
remote: After a few seconds,
the remote starts up
automatically and an
Introduction screen appears.
The remote control beeps twice to indicate that it has started up successfully.
1. Do not mix an old battery with a new one or different types of
Note
batteries.
2. If you will not use the remote control for a long time, remove the
batteries to avoid damage from battery leakage.
The remote control can be used to control the VX-6000d within the ranges shown in
Figure 3-1.
Approx.
30m /100ft
Figure 3-1. Available Range of the Remote Control
Runco VX-6000d Owner's Operating Manual
Touch-Screen Remote
markings
Approx.
7m /23ft
Standard DHD Remote
19

3. Installation

3.1

Remote Control

Battery Installation

Notes on Remote Control
Operation