Installing And Adjusting The Cinewide Anamorphic Lens; Anamorphic Lens Installation And Adjustment; Anamorphic Lens Mounting Assembly - Exploded View - Runco Quantum Color Q-750d Series Installation & Operation Manual

5. Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method. Or, for front-projection installations, use the Auto setting to
have the projector automatically determine the orientation (floor or ceiling) using an
internal sensor.
If you are installing a Q-750d/CineWide or Q-750d/CineWide with AutoScope, proceed as
follows to install and adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The Q-750d Anamorphic lens mount kit consists of everything shown in Figure 3-20.
Some components shipped with your projector may differ slightly from what is shown in
these instructions. If any items are missing or damaged, please contact your Runco dealer
or Runco Customer Service at (800) 23-RUNCO.
1
Anamorphic Lens
10
Set Screw
9
Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-20. Anamorphic Lens Mounting Assembly - Exploded View
Q-750d Series Installation/Operation Manual
Lens Adapter Ring and
Mounting Screws (3x)
2
Pitch Adjustment Yoke for Lens
3
Height/Y Adjustment
T-Screw and Washer
(2x)
4
Pitch Adjustment
T-Screw and
Washer (2x)
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate or
Fixed CineWide Base Plate
41
Installation
3.10
Installing and
Adjusting the
CineWide Anamorphic
Lens
Anamorphic Lens
Installation and
Adjustment