Controls And Functions; Q-750D At A Glance - Runco Quantum Color Q-750d Series Installation & Operation Manual

Figure 2-1 shows the key Q-750d components.
Top IR Sensor
Status LED Exhaust Vent
Figure 2-1. Q-750d Front/Bottom/Side/Top Views
• TOP IR SENSOR
Receives infrared signals from the remote control unit.
• INTAKE VENT
Internal fans draw cool air into the projector through this vent.
• RUNCO LOGO
The logo can be rotated to match the projector orientation: inverted (ceiling-mounted)
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and
rotate it 180 degrees.
• FOCUS RING
Rotate this to focus the projected image.
• PROJECTION LENS
Available in two versions: standard throw range (1.85:1 to 2.40:1) and short throw
range (1.56:1 to 1.86:1).
• FRONT BEZEL RETAINING SCREW
Loosen this screw to allow removal of the decorative front bezel, which provides
access to the lens shift controls (refer to Lens Shift on page 34).
• ZOOM RING
Rotate this to change the projected image size.
Q-750d Series Installation/Operation Manual

2. Controls and Functions

Zoom Ring
Front IR Sensor
5
2.1

Q-750d at a Glance

Intake Vent
(on side)
Runco Logo
Focus Ring
Projection Lens
Front Bezel
Retaining
Screw