Connecting To Ac Power; Turning On The Power - Runco VIDEOXTREME VX-8D Installation & Operation Manual

Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the VX-8d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
The input voltage to the AutoScope lens motor must be between
Caution
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
1. Turn on your source components.
2. Turn on the main power switch at the rear of the projector.
3. Turn on the main power switch at the rear of the DHD Controller.
4. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input.
5. Press the ON button on the remote control (or the ON/STANDBY (
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays "Initializing System," followed by
"Starting VX-8d."
6. When the projector is ready for use, the fluorescent display indicates the active
source, input resolution/frame rate and aspect ratio; for example:
VX-8d
16:9
Aspect Ratio
Runco VX-8d Installation/Operation Manual
Current
Source
HDMI 1
1080i/60
Input Resolution/Frame Rate
39

Connecting to AC Power

3.7

Turning on the Power

) button on
Installation