Installing And Adjusting The Cinewide Anamorphic Lens; Anamorphic Lens Installation And Adjustment; Anamorphic Lens Mounting Assembly - Exploded View - Runco VIDEOXTREME VX-8D Installation & Operation Manual

If you are installing a VX-8d/CineWide or VX-8d/CineWide with AutoScope, proceed as
follows to install and adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The VX-8d Anamorphic lens mount kit consists of everything shown in Figure 3-20. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23-RUNCO.
1
Anamorphic Lens
10
Set Screw
9
Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-20. Anamorphic Lens Mounting Assembly - Exploded View
Runco VX-8d Installation/Operation Manual
Lens Adapter Ring and
Mounting Screws (3x)
2 Pitch Adjustment Yoke for Lens
3
Height/Y Adjustment
T-Screw and Washer
(2x)
4
Pitch Adjustment
T-Screw and
Washer (2x)
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate or
Fixed CineWide Base Plate
41
Installation
3.10
Installing and
Adjusting the
CineWide Anamorphic
Lens
Anamorphic Lens
Installation and
Adjustment