Button Lighting - Mercedes-Benz COMAND Operating Instructions Manual

Hide thumbs Also See for COMAND:
Table of Contents

Advertisement

Rear Seat Entertainment System overview
274
Selecting the screen for the remote con-
trol
You can use the remote control to operate
one of the two rear screens at a time. To do
so, you must switch the remote control to the
desired screen.
To select the left-hand screen: turn thumb-
X
wheel : until "L REAR" appears in the win-
dow.
To select the right-hand screen: turn the
X
thumbwheel until "REAR R" appears in the
window.
To select the COMAND screen: turn thumb-
X
wheel : until "COMAND" appears in the
window.
Please be aware that using the thumbwheel
to select screens may cause unwanted
changes to the screens of your occupants.
Up to four remote controls can be used in the
vehicle at the same time.
Switching the screen on/off
The switched-on rear compartment screens
switch off after 30 minutes if:
the SmartKey is in position 0 or 1 in the
R
ignition lock
the SmartKey is not inserted
R
Before the screens switch off, they show a
message to this effect.
You can switch the screens back on. Please
note that this may cause the starter battery to
discharge.
Press button : on the remote control.
X
The respective rear-compartment screen
switches on or off.
You can only switch the screens on using
i
the remote control if the ignition is
switched on.
Switching the button lighting on/off
Lighting of the remote control buttons is
X
divided into three areas. The corresponding
area is activated every time you press a
button. It switches off again automatically
5 to 10 seconds after the last button has
been pressed.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Comand

Table of Contents