Switching To - Mercedes-Benz COMAND Operating Instructions Manual

Video AUX mode
238
Switching to audio AUX mode
Connect an external audio source.
X
The socket for the audio AUX jack is located
in the stowage compartment in the center
console.
The audio AUX is not selected automati-
cally.
Press the Õ button.
X
The menu for the last accessed media
source appears.
To select Media: slide 5 and press the
X
controller.
The menu appears with the available media
sources.
To select Aux: turn and press the controller.
X
The audio AUX menu appears. The medium
is played if the audio source is switched on
and playback is activated.
Please see the manufacturer's operating
instructions for how to operate the external
audio source.
Setting the audio AUX options
To show the menu bar: slide 6 the con-
X
troller.
To select Options: turn and press the con-
X
troller.
A menu appears. You can set
and Volume.
Mono/stereo:
To select Mono/Stereo: turn and press the
X
controller.
A menu appears.
Select
X
The # dot indicates the current setting.
Volume:
To select Volume: turn and press the con-
X
troller.
Select
X
Standard: the volume of the external audio
source is adjusted to a standard value.
Boost: the volume of the external audio
source is raised by approximately 10 dB.
The # dot indicates the current setting.
Traffic announcements:
A device which is connected as an external
audio source may seem quieter or louder in
the vehicle, or the usual maximum volume
cannot be achieved. On some devices, it is
possible to adjust the volume separately. In
this case, start at a medium volume and
increase it gradually. This enables you to
determine whether the system is able to play
the music at high volume without distorting it.
Video AUX mode
Connecting external video sources
External video sources may have different
volumes, which can mean that system mes-
sages such as traffic announcements and
navigation system announcements are much
louder. If necessary, deactivate the system
messages or adjust their volume manually.
Video AUX is another option for showing vid-
eos using COMAND.
Mono/Stereo
To connect an external video source to the
video AUX, you will require a video AUX cable.
If you only use an audio AUX cable, you
i
will only be able to hear the sound from the
video being played.
Mono or Stereo.
Standard or Boost.