Connection Panel (Bottom Of Instrument) - Hach ORBISPHERE G1100 User Manual

Installation
Alternative instrument mounting procedure
When it is not convenient to work from the back of the panel, the instrument can be connected
before fitting in the panel.
1. Install the panel support frame in the panel opening
2. Slip the cables through the panel opening
3. Remove the instrument cover
4. Slip the cables through the instrument cover
5. Slip the cables through the instrument back panel cable glands
6. Connect the cables to the instrument electronic boards
7. Tighten the cable glands
8. Reinstall the instrument cover
9. Install the instrument in the panel opening

3.4.3 Connection panel (bottom of instrument)

1. Power cable
2. Ethernet cable gland
3. USB-A host connector for mass storage
4. USB-B 4 pin connector (reserved for
5. Sensor - blue cable connection
6. Sensor - red cable connection
Note: The type of connection will vary depending on the instrument specification.
28
device
Hach Lange service technicians)
Figure 11 Panel mount connection panel
7. Sensor - temperature connection (black
cable)
8. Input/Output 2 cable gland
9. Input/Output 1 cable gland
10. Flow chamber solenoid valve connection
11. External pressure sensor connection