Table of Contents
Advertisement
68
Fig. 45: Oil level indicator
MAX
MIN
1. Fill oil through the filler hole (1) to a maximum of 2 mm below
the maximum level marking (2).
NOTICE
MMachine damage possible due to incorrect oil level.
Too little or too much oil can damage the machine.
During initial filling, only pour in oil up to 2 mm below the
maximum level marking.
Required oil:
Only DA 10 or equivalent oil should be used for the machine, which
has the following properties:
• Viscosity at 40 °C: 10 mm²/s
• Flash point: 150 °C
NOTICE
Machine damage possible due to incorrect oil.
An incorrect oil type can cause damage to the machine.
Only use oil specified in the operating instructions.
CAUTION
Risk of pollution from oil.
Oil is a pollutant and must not enter the sewage
system or the soil.
Collect waste oil carefully and dispose of it and
oily machine parts in accordance with the
applicable statutory regulations.
Operating Instructions 878-M PREMIUM - 02.0 - 02/2018
1
2
(1) - Filler opening
3
(2) - Maximum level marking
(3) - Minimum level marking
Setup
Advertisement
Table of Contents
