Table of Contents
Advertisement
60
7.8 Mounting the machine head
Fig. 37: Mounting the machine head
(1) - Upper hinge parts
(2) - Rubber inlays
CAUTION
Risk of crushing!
The machine head is very heavy.
Take care not to jam your hands when fitting the
machine head.
This especially applies when fitting the upper
hinge parts into the rubber inlays.
1. Screw the upper hinge parts (1) onto the machine head.
2. Insert the machine head vertically in the recess in the table top.
3. Insert the upper hinge parts (1) into the rubber inlays (2).
4. Above the right hinge place the locking plate (3) and screw it
with two screws to the table.
Operating Instructions 878-M PREMIUM - 02.0 - 02/2018
①
②
③
(3) - Locking plate
Setup
Advertisement
Table of Contents
