Setting Mode; Buzzer Sound Setting; Needle Stop Position Setting - ELNA lotus 2 Instruction Manual

e
r
t
y
u
w
w
q
w
q
q
e

Setting Mode

Press the set key q to enter the machine setting mode
for customizing the machine setting.
The LCD display will show "01", "on" (ON) and "oF" (OFF),
and the "on" mark will blink.
Each time you press the arrow key w, the mode
number changes, and you can set the following machine
functions as follows:
e Mode number
r Buzzer sound setting
t Needle stop position setting
y Key position calibration
u Resetting all to default
Press the set key q to apply the machine settings and
exit the machine setting mode.
NOTE:
Customized machine settings will not apply if you turn
off the machine while in the machine setting mode.

Buzzer sound setting

The buzzer sound can be turned on or off using the
buzzer sound setting.
Enter the setting mode.
The default buzzer sound setting is "ON".
To turn the buzzer sound off, press the stitch length
adjusting button " " q, and the "oF" mark will blink.
To turn the buzzer sound on, press the stitch width
adjusting button " " w, and the "on" mark will blink.
* Caution buzzer sound cannot be turned off.

Needle stop position setting

You can set the needle position to up or down when the
machine stops.
Enter the setting mode.
Press the right arrow key q to select the needle stop
position setting.
The default up/down needle position setting is "dn" (down).
To change the needle position to up, press the stitch
width adjusting button "
blink.
To change the needle position to down, press the stitch
length button " " e, and the "dn" mark will blink.
24
" w, and the "uP" mark will