Winding The Bobbin - ELNA lotus 2 Instruction Manual

z
c
e
w
b
m
,
x
q
v
n
r
Winding the bobbin
NOTE:
• Set the speed control slider at its fastest position
for bobbin winding.
• Close the retractable thread guide e after the
bobbin winding.
z Turn the spool thread guide as illustrated.
Draw the thread from the spool and pass it through
the spool thread guide.
x Pass the thread through the thread guide (A).
c Raise the retractable thread guide.
Guide the thread around the bobbin winder thread
guide (A) q and (B) w as illustrated.
v Pass the thread through the hole in the top of the
bobbin from the inside to outside.
b Put the bobbin on the bobbin winder spindle.
n Push the bobbin to the right. The bobbin mark r
appears on the LCD display.
m With the free end of the thread held in your hand,
start the machine. Stop the machine when bobbin has
wound a few layers, and then cut the thread close to
the hole in the bobbin.
, Start the machine again. When the bobbin is fully
wound, it will stop automatically. Stop the machine
and return the bobbin winder to its original position
by moving the spindle to the left. Cut the thread as
shown.
19