Table of Contents
Advertisement
q
e
q
w
Setting Mode
In the setting mode, you can set the following functions.
To enter the setting mode, turn the power switch off.
Press and hold the needle up/down button q and
turn the power switch on until the setting mode screen
appears.
Needle stop position setting
You can set the needle stop position to up or down when
the machine stops.
The default setting is up and "uP" sign appears on the
screen.
To change the needle position setting, press "+" or "–" on
the stitch length adjusting key w.
The "dn" sign appears and the needle stop position is set
to down.
w
Press the START/STOP button e to apply the setting.
Auto-off timer
The machine will be turned off if you do not use the
machine within the time period set by this timer.
Enter the setting mode (refer to the "Setting Mode" above).
Press "
The setting screen "Auto-off timer" appears (02).
The default auto-off timer setting is 7 hours and "07" sign
appears on the screen.
Press "+" or "–" on the stitch length adjusting key w to
increase or decrease the setting value.
The auto-off timer can be set from 1 to 12 hours.
If you wish to turn off the timer, press and hold the "+" or "–"
key w until "oFF" sign appears on the screen.
Press the start/stop button e to apply the setting.
e
21
NOTE:
The auto-off timer is available in EU countries and
some regions which use 200 - 240 voltage standards.
" or "
" key q under the first digit number.
Advertisement
Table of Contents
