Maintenance; Clean The Product; Change The Batteries - Fluke 2700G Calibration Manual

2700G
Calibration Manual

Maintenance

Clean the Product

Clean the Product with a soft cloth dampened with water or water and weak
soap.
To prevent possible damage to the Product, do not use
solvents or abrasive cleansers.
For safe operation and maintenance of the product:
•
•
•
•

Change the Batteries

To prevent possible electrical shock, fire, or personal injury,
have an approved technician repair the Product.
To change the batteries, see Figure 1:
1. Pull off the Product cover.
2. Use a Phillips screwdriver to loosen the captive screw on the battery door.
3. Remove the battery door.
4. Replace the three AA batteries, note the correct polarity.
5. Install the battery door again.
6. Tighten the captive screw.
7. Put the Product cover back on.
4
Repair the Product before use if the battery leaks.
Remove batteries to prevent battery leakage and damage to
the Product if it is not used for an extended period.
Be sure that the battery polarity is correct to prevent battery
leakage.
Have an approved technician repair the Product.
Caution
Caution
Warning