Upflow Model Installed Vertically; Drain Exiting Right Side - Goodman MEC961205DN Instruction Manual

#2
#1
#4
#7
#9
Figure 20
NOTE: Hoses are model specific
and not all hoses will be shipped with all models.
E
DGES OF SHEET METAL HOLES MAY BE SHARP
PRECAUTION WHEN REMOVING HOLE PLUGS
HIGH VOLTAGE !
T ,
O AVOID THE RISK OF INJURY
,
DEATH THE FURNACE MUST BE ELECTRICALLY
GROUNDED IN ACCORDANCE WITH LOCAL CODES OR IN
,
THEIR ABSENCE WITH THE LATEST EDITION OF THE
N E C .
ATIONAL LECTRIC ODE
T ,
O AVOID THE RISK OF INJURY
FURNACE MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE WITH
,
LOCAL CODES OR IN THEIR ABSENCE
N E C .
ATIONAL LECTRICAL ODE
#5
#8
#10 Coupling
100 Degree
Elbow
#11
WARNING
. U
SE GLOVES AS A
.
WARNING
ELECTRICAL SHOCK OR
WARNING
,
ELECTRICAL SHOCK OR DEATH THE
,
WITH THE LATEST EDITION OF THE
U M I
PFLOW ODEL NSTALLED
The trap and factory installed hoses remain as shipped. The
furnace drain may exit either the right or left side of the
furnace cabinet. Both sides of the cabinet have two .875"
diameter holes which can be used interchangeably for drain
and low voltage wiring purposes. If a higher drain exit is
needed, a .875" diameter hole may be added in the area
shown in Figure 21. Any unused cabinet opening must be
sealed. Do not allow drain hose to sag or trap water.
Acceptable
area for
drain hole.
12"
D E R
RAIN XITING IGHT
1. Locate and Install the 45º pipe / hose drain coupling
from the outside of the cabinet (barbed end goes in
the cabinet) through hole in the right side of the cabinet
and secure with two field supplied #8 self-tapping
screws (see Figure 22).
2. Locate the long drain hose #3 and cut at line "A" .
3. Install large end of hose #3 to trap outlet and secure
with 1.25" clamp.
4. Install smaller end of hose #3 on 45º elbow and secure
with 1" clamp.
5. Refer to Field Supplied Drain section for instructions
on field supplied / installed drain on outlet of furnace
trap.
19
V
ERTICALLY
Side Cut-Out
Right side shown.
3"
Figure 21
S
IDE