About the effects Insert mode
This section describes Insert mode.
1. Press [UTILITY].
2. Press CURSOR [
] [
and press [ENTER].
3. Make the setting with the TIME/VALUE dial.
Insert Mode
Valid Settings:
INPUT<NORMAL>, INPUT<REC DRY>, TRACK 1–8,
TRACK 1&2–7&8, RHYTHM, MASTER
(Initial value: INPUT<NORMAL>)
This sets the target to which the insert effects are applied.
You can use this setting to apply insert effects to sounds that
have already been recorded to the tracks.
INPUT<NORMAL>:
Effects are applied to the input source. This mode is normally
set as the default.
fig.05-801
TRACK 1
(REC)
INPUT<REC DRY>:
You can monitor the sound of the input source with the
effects applied, but only the dry sounds, without the effects
applied, are recorded.
fig.05-802
TRACK 1
(REC)
TRACK 1–8, TRACK 1&2–7&8:
Effects are applied to each of the selected tracks.
fig.05-803
] to move the cursor to "SYS,"
TRACK 1
(PLAY)
Utility parameter list
RHYTHM:
Effects are applied to the Rhythm Guide sounds.
fig.05-804
MASTER:
Effects are applied to the sounds from the master output.
fig.05-805
Rhythm
Guide
TRACK 1
(PLAY)
TRACK 2
(PLAY)
TRACK 8
(PLAY)
Rhythm
Guide
153