Roland V-Synth Owner's Manual page 135

36: Rhodes Multi
Enhancer, Phaser, Chorus or Flanger, and Tremolo or Auto-pan are
connected in series. This effect is used for electric piano.
fig.MFX-36
L
Enhancer Phaser
R
Chorus/
Flanger
Parameter Value
Enhan Sw OFF, ON
Enhan Sens 0–127
Enhan Frequen- 0–127
cy
Enhan Mix Lev- 0–127
el
Enhan Level 0–127
Phaser Manual 0–127
Phaser Rate 0.05–10.0 Hz,
note
Phaser Depth 0–127
Phaser Reso- 0–127
nance
Phaser Mix Lev- 0–127
el
Mod Mode CHORUS,
FLANGER
Mod Rate 0.05–10.0 Hz,
note
Mod Depth 0–127
Mod Phase 0–180 deg
Mod Pre Delay 0–50.0 ms
Mod Feedback -98– +98 %
Mod XoverLPF 500–15000 Hz,
THRU
Mod XoverHPF THRU, 50–800
Hz
Mod Level 0–127
Tremolo/
Auto Pan
Description
Turns the enhancer effect on/
off.
Sensitivity of the enhancer
Sets the lower limit of the fre-
quencies to which the enhance-
ment effect is added.
Level of the overtones generated
by the enhancer
Volume of the enhancer sound
Specifies the center frequency at
which the sound is modulated.
Specifies the frequency of mod-
ulation.
Specifies the depth of modula-
tion.
Specifies the amount of feed-
back for the phaser.
Higher settings will give the
sound a stronger character.
Specifies the volume of the
phase-shifted sound, relative to
the direct sound.
Selects whether to use chorus or
flanger.
Adjusts the speed of modulation
for the chorus or flanger.
Adjusts the depth of modulation
for the chorus or flanger.
Sets how the chorus or flanger
sound is spread.
Adjusts the delay time from the
direct sound until the chorus or
flanger sound is heard.
Adjusts the proportion of the ef-
fect sound that is fed back into
the effect. Negative (-) settings
will invert the phase.
Adjusts the cutoff frequency of
the low pass filter. (THRU: no
filter is used)
Adjusts the cutoff frequency of
the high pass filter. (THRU: no
filter is used)
Volume of the chorus or flanger
sound.
Parameter Value
Trem/Pan Sw OFF, ON
Trem Mode TREMOLO,
AUTO PAN
Trem Wave- TRI, SAWUP,
form SAWDN, SQR,
SIN
SAWUP
Trem Rate 0.05–10.0 Hz,
note
Trem Depth 0–127
37: Keyboard Multi
A ring modulator, 3-band equalizer, pitch shifter, phaser, and delay
are connected in series.
Ring Modulator is an effect which applies ring modulation using an
internal oscillator to the input signal, producing bell-like sounds.
fig.MFX-37
L
Ring 3-Band
Modulator EQ
R
Phaser
Parameter Value
Ring Freq 0–127
Ring Balance #1 DRY100:0WET–
DRY0:100WET
EQ Low Freq 50–4000 Hz
EQ Low Gain -15– +15 dB
EQ Mid Freq 50–20000 Hz
EQ Mid Q 0.5, 0.7, 1.0, 2.0,
4.0, 8.0
EQ Mid Gain -15– +15 dB
EQ Hi Freq 2000–20000 Hz
EQ Hi Gain -15– +15 dB
PS Grade 1–5
Effects List
Description
Turns the tremolo/auto pan ef-
fect on/off.
Selects whether to use tremolo
or auto pan.
Selects the type of modulation.
TRI: Triangle wave
SAWUP/SAWDN: Sawtooth
Wave
SQR: Square wave
SIN: Sine wave
SAWDN
Frequency of modulation
Depth of modulation
Pitch
Shifter
Delay
Description
Frequency at which modulation
will be applied
Volume balance between the di-
rect sound (DRY) and the ring
modulated sound (WET)
Frequency of the low range
Gain of the low range
Frequency of the middle range
Gain of the middle range
Set a higher value for Q to nar-
row the range to be affected.
Gain of the middle range
Frequency of the high range
Gain of the high range
Sets the grade of the effect
sound.
The higher the value is set, the
more natural-sounding can be
obtained; however, this increas-
es the delay from the source
sound as well.
135