Roland V-Synth Owner's Manual page 130

Effects List
27: Stereo Pitch Shifter
This effect features two pitch shifters arranged in parallel, making it
stereo compatible. It can shift the pitch of the input signal up to one
octave up or down.
fig.MFX-27
L
A
Stereo Pitch Shifter
B
R
Parameter Value
Input Mode MONO, STE-
REO
Grade 1–5
Coarse Pitch A/ -12– +12 semi-
B #1/#2 tone
Fine Pitch A/B -100– +100 cent Adjusts the pitch shift amount in
Pre Delay A/B 0–500 ms
Level A/B 0–127
Pan A/B L63–63R
Direct Level 0–127
Feedback #3 -98– +98 %
Low Damp Freq 50–4000 Hz
Low Damp -36–0 dB
Gain
Hi Damp Freq 2000–20000 Hz
Hi Damp Gain -36–0 dB
Ps Low Freq 50–4000 Hz
Ps Low Gain -15– +15 dB
Ps Hi Freq 2000–20000 Hz
Ps Hi Gain -15– +15 dB
130
2-Band
EQ
Description
Selects either stereo input or
monaural input.
Sets the grade of the effect
sound.
The higher the value is set, the
more natural-sounding can be
obtained; however, this increas-
es the delay from the source
sound as well.
Specifies the pitch shift amount
in semitones for pitch shift A or
B.
2-cent units (1 cent = 1/100 of a
semitone) for pitch shift A or B.
Adjusts the delay time from the
direct sound until the pitch shift
A or B sound is heard.
Volume of the pitch shift A or B
sound.
Pan of the pitch shift A or B
sound.
Volume of the direct sound.
Adjusts the proportion of the
pitch shift sound that is fed back
into the effect. Negative (-) set-
tings will invert the phase.
Adjusts the frequency below
which sound fed back to the ef-
fect will be cut.
The Low Damp function damps
the low frequency band of the
pitch shift sound quicker than
other bands.
Degree of Low Damp
Adjusts the frequency above
which sound fed back to the ef-
fect will be cut.
High Damp, by attenuating the
higher frequencies first.
Degree of High Damp
Frequency of the low range
Gain of the low range
Frequency of the high range
Gain of the high range
28: OD/DS Cho/Flg (Overdrive/
Distortion Chorus/Flanger)
This effect connects either Overdrive or Distortion and either Chorus
or Flanger.
fig.MFX-28
L
Overdrive/
Distortion
R
Parameter Value
Distortion OD, DS
Mode
Drive #1 0–127
Amp Sim Sw OFF, ON
Amp Type SMALL,
BUILT-IN, 2-
STACK, 3-
STACK
Distortion Level 0–127
Mod Mode CHORUS,
FLANGER
Mod Rate #2 0.05–10.0 Hz,
note
Mod Depth 0–127
Mod Phase 0–180 deg
Mod Pre Delay 0–50.0 ms
Mod Feedback -98– +98 %
Xover LowFreq 50–4000 Hz
Xover Low Gain -36–0 dB
Xover HiFreq 2000–20000 Hz
Xover Hi Gain -36–0 dB
Mod Level 0–127
Ps Low Freq 50–4000 Hz
Ps Low Gain -15– +15 dB
Ps Hi Freq 2000–20000 Hz
Ps Hi Gain -15– +15 dB
Chorus/ 2-Band
Flanger EQ
Description
Selects whether to use overdrive
(OD) or distortion (DS).
Degree of distortion
Turns the amp simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack
amp
3-STACK: large triple stack amp
Volume of the overdrive or dis-
tortion sound.
Selects whether to use chorus or
flanger.
Adjusts the speed of modulation
for the chorus or flanger.
Adjusts the depth of modulation
for the chorus or flanger.
Sets how the chorus or flanger
sound is spread.
Adjusts the delay time from the
direct sound until the chorus or
flanger sound is heard.
Adjusts the proportion of the ef-
fect sound that is fed back into
the effect. Negative (-) settings
will invert the phase.
Attenuates the effect in the
range below the specified fre-
quency.
Specifies how greatly the low
range will be attenuated.
Attenuates the effect in the
range above the specified fre-
quency.
Specifies how greatly the high
range will be attenuated.
Volume of the chorus or flanger
sound.
Frequency of the low range
Gain of the low range
Frequency of the high range
Gain of the high range