Sampling Procedure - Roland V-Synth Owner's Manual

Creating and Editing Samples (Sample Mode)
Setup Comp
SamplingType 0 (Stereo)
InputSource 0 (Analog)
TriggerMode 0 (Manual) 0 (Manual) 0 (Manual) 1 (MIDI)
TriggerLevel -12 (dB)
PreTrigger 0 (0msec)
PreGain 0 (0dB)
PreFxType 1 (COMP)
PreFxCS-Sus 64
PreFxCS-Atk 12
PreFxCS-Tone 0
PreFxCS-Lvl 0
PreFxLM-Thr -48
PreFxLM-Rel 0
PreFxLM-Rati 0
PreFxLM-Tone 0
PreFxLM-Lvl 0
PreFxNS-Thr -60
PreFxNS-Rel 0
CountIN 1 (1MES)
MetroType 1 (REC)

Sampling Procedure

Here's how to input a sound from the input jacks and sample it. For
resampling, refer to the following section.
The V-Synth has the following input jacks.
• INPUT L, R (GAIN: MIC/LINE)
• DIGITAL AUDIO INTERFACE
OPTICAL IN
COAXIAL IN
Use the input jack that is appropriate for your situation.
• Monaural sampling from a mic
• Sampling from an analog source
• Sampling from a digital source
Howling could be produced depending on the location of
microphones relative to speakers. This can be remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
56
Limiter NoiseSup MIDI
0 (Stereo) 0 (Stereo) 0 (Stereo)
0 (Analog) 0 (Analog) 0 (Analog)
-12 (dB) -12 (dB) -12 (dB)
0 (0msec) 0 (0msec) 0 (0msec)
0 (0dB) 0 (0dB) 0 (0dB)
2 (LIMIT) 3 (NS) 0 (off)
0 0 0
0 0 0
0 0 0
0 0 0
-36 -48 -48
80 0 0
2 0 0
0 0 0
0 0 0
-60 -30 -60
0 22 0
1 (1MES) 1 (1MES) 0 (0MES)
1 (REC) 1 (REC) 1 (REC)
INPUT L, R (GAIN: MIC)
INPUT L, R (GAIN: LINE)
OPTICAL IN or COAXIAL IN
When sampling, you must make sure that the following two items
are set correctly. If these two settings are incorrect, the sample will
not be recorded as you intend.
• What type of sample are you recording? (stereo or mono)
In the SAMPLING General screen, set Sampling Type.
• Which input are you sampling from? (select the input jack)
In the SAMPLING General screen, set Input Source.
If you have set the metronome (p. 62), the metronome sound will
be output from the DIRECT OUT jack during sampling.
However, the sound that is assigned to the DIRECT OUT jack (p.
50) will not be output.
1. Press [MODE].
The V-SYNTH MODE MENU window appears.
fig.MODE_50
2. Touch <SAMPLE>.
The SAMPLE Top screen appears.
fig.04-01_50