Rear Panel; Phones Jack; Gnd Terminal - Roland RD-700 Owner's Manual

Roland piano owners manual rd-700
Hide thumbs Also See for RD-700:
Table of Contents

Advertisement

Panel Descriptions

Rear Panel

2
1
3
1

GND Terminal

Connect using a grounded cable (optional) as conditions
require.
In some cases, depending on the environment in which the
unit is installed, the surface of the panel may sometimes feel
rough and grainy. This is due to an infinitesimal electrical
charge, which is absolutely harmless. However, if you are
concerned about this, connect the ground terminal with an
external ground. When the unit is grounded, a slight hum
may occur, depending on the particulars of your installation.
If you are unsure of the connection method, contact the
nearest Roland Service Center, or an authorized Roland
distributor, as listed on the "Information" page.
Unsuitable places for connection
- Water pipes (may result in shock or electrocution)
- Gas pipes (may result in fire or explosion)
- Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
2
[POWER] Switch
Switch turns the power on/off (p. 24).
3
AC Inlet
Connect the included power cable to this inlet. (p. 22).
4
Wave Expansion Board Installation
Slot
Remove the cover for installation of optional wave expansion
boards (SRX Series) (p. 15).
5
MIDI Connectors (IN, OUT, THRU)
Used for connecting external MIDI devices and for
transmission of MIDI messages (p. 22, p. 59, p. 95).
14
4
5
MIDI
THRU
OUT
IN
6
PEDAL Jacks (DAMPER, FC1, FC2)
Connecting the pedal switch (DP-6) provided with the RD-
700 to the DAMPER jack allows you to use the switch as a
damper pedal.
With an optional expression pedal (such as the EV-5 or other
model) connected to the FC-1 or FC-2 jack, you can then
assign a variety of functions to the pedal (p. 23, p. 73).
7
OUTPUT R/L (MONO) Connectors
Provide output of the audio signals. These are connected to
an amp or other device. For monaural output use the L/
MONO jack (p. 22).
These also feature balanced output.
8

PHONES Jack

A set of headphones can be connected to this jack (p. 22).
Even when headphones are connected, sound will still be
output from the output jacks.
6
7
8
PEDAL
OUTPUT
DAMPER
FC 1
FC 2
R
L(MONO)
PHONES
BALANCED
TIP
HOT
RING
COLD
SLEEVE
GND

Advertisement

Table of Contents
loading

Table of Contents