Midi Send Channel Settings - Roland RD-700 Owner's Manual

Using the RD-700 As a Master Keyboard

MIDI Send Channel Settings

When you have finished connecting the external MIDI device, match the
keyboard's Transmit channel and the Receive channel for each of the
external MIDI sound generator's Parts. Sounds is produced when the MIDI
channels for the sending device (the RD-700) and the receiving device (the
external MIDI sound generator) are set to the same MIDI channel.
fig.panel
CONTROL
1
Press [MIDI TX], getting the indicator to light.
The MIDI Tx screen appears.
If "Ch" doesn't appear on screen, press CURSOR [
display the following screen.
fig.LCD
2
Press CURSOR [
then press [INC/YES] or [DEC/NO] to set the Transmit
channel (Ch) for each part.
Part
UP1 (UPPER1)
UP2 (UPPER2)
LWR (LOWER)
RHY (RHYTHM)
60
], [ ], [ ], or [ ] to move the cursor,
Settings
1–16
2
] several times to
Description
RD-700 performance
data is sent over a select-
ed channel.
You can save the
keyboard's Transmit
channel to a Setup (p. 56).
1
For instructions on setting
each of the external MIDI
sound generator's Part's
Receive channel, refer to
the owner's manual for
each device.
Part names for Parts in
which PART SWITCH is
set to OFF appear in the
display in lowercase letters,
such as "up1," "up2,"
"lwr," and "rhy."
MIDI messages for Parts
with the PART SWITCH set
to OFF are not transmitted.
NOTE
When Rec Mode is set to
ON in the Utility Rec
Setting in Edit mode, the
MIDI TX screen as shown
to the left is not displayed.
Set Rec Mode to OFF when
setting the MIDI Transmit
channel (p. 95).