Table of Contents
Advertisement
Front and Rear Panel
Rear Panel
Power Switch
Press to turn the power on/off.
AC Inlet
Connect the AC power cable (included) to this inlet.
* With units rated for 117V operation, the AC cable is already
connected to the unit.
fig.0-02a
MEMORY CARD Slot
An optional memory card (SmartMedia) can be inserted here.
p. 115
fig.0-02b
MIDI Connectors (IN, OUT, THRU)
These connectors can be connected to other MIDI devices to
receive and transmit MIDI messages.
fig.0-02c
COMPUTER Switch
Set this switch depending on the type of computer connected
to Computer connector, or the software you are using. Turn
the power off before changing the setting of this switch. If
you wish to use the MIDI connectors, set this switch to MIDI.
p. 134
COMPUTER Connector
A special Computer cable (sold separately) can be connected
here. The type of cable required will depend on your computer.
When the Computer switch located at the left is set to MIDI,
this connector cannot be used.
fig.0-02d
14
p. 26
p. 24
p. 24, 119, 132
p. 134
CONTROL PEDAL Jack
You can connect optional expression pedals to these jacks. By
assigning a desired function to a pedal, you can use it to
select or modify sound or perform various other control. You
can also connect optional pedal switches to sustain sound.
p. 24, 110
HOLD PEDAL Jack
An optional pedal switch can be connected to this jack for
use as a hold pedal.
p. 24, 110
fig.0-02e
OUTPUT Jacks (L (MONO), R)
These jacks output the audio signal to the connected mixer/
amplifier system in stereo. For mono output, use the L jack.
p. 24
PHONES Jack
An optional set of headphones can be connected to this jack.
p. 24
fig.0-02f
Advertisement
Table of Contents
