Table of Contents
Advertisement
General Purpose Controller 6 (Controller number 81)
status
2nd byte
BnH
51H
n=MIDI channel number:
0H - FH (ch.1 - ch.16)
vv=control value:
00H - 40H - 7FH (-128 - 0 - +126)
General Purpose Controller 7 (Controller number 82)
status
2nd byte
BnH
52H
n=MIDI channel number:
0H - FH (ch.1 - ch.16)
vv=control value:
00H - 40H - 7FH (-128 - 0 - +126)
General Purpose Controller 8 (Controller number 83)
status
2nd byte
BnH
53H
n=MIDI channel number:
0H - FH (ch.1 - ch.16)
vv=control value:
00H - 40H - 7FH (-128 - 0 - +126)
Portamento Control (Controller number 84)
status
2nd byte
BnH
54H
n=MIDI channel number:
0H - FH (ch.1 - ch.16)
kk=source note number:
00H - 7FH (0 - 127)
Effect 1 (Reverb Send Level) (Controller number 91)
status
2nd byte
BnH
5BH
n=MIDI channel number:
0H - FH (ch.1 - ch.16)
vv=Reverb Send Level:
00H - 7FH (0 - 127)
Effect 3 (Chorus Send Level) (Controller number 93)
status
2nd byte
BnH
5DH
n=MIDI channel:
0H - FH (ch.1 - ch.16)
vv=Chorus Send Level:
00H - 7FH (0 - 127)
RPN MSB/LSB (Controller number 100,101)
status
2nd byte
BnH
65H
BnH
64H
n=MIDI channel number:
0H - FH (ch.1 - ch.16)
mm=MSB of the parameter number specified by RPN
ll=LSB of the parameter number specified by RPN
This device transmits the following RPNs.
RPN
Data entry
MSB LSB
MSB LSB
00H 00H
mmH -
00H 01H
mmH llH
00H 02H
mmH -
Program Change
status
2nd byte
CnH
ppH
n=MIDI channel:
0H - FH (ch.1 - ch.16)
pp=Program number:
00H - 7FH (prog.1 - prog.128)
* This message is not transmitted when the Program parameter (SYSTEM/MIDI/
TRANSMIT MIDI) is OFF.
Channel Aftertouch
status
2nd byte
DnH
vvH
n=MIDI channel:
0H - FH (ch.1 - ch.16)
vv=Channel Aftertouch:
00H - 7FH (1 - 128)
3rd byte
vvH
3rd byte
vvH
3rd byte
vvH
3rd byte
kkH
3rd byte
vvH
3rd byte
vvH
3rd byte
mmH
llH
Notes
Pitch Bend Sensitivity
mm : 00H - 0CH (0 - 12 semitones)
ll : 00H
Channel Fine Tuning
mm, ll : 20 00H - 40 00H - 60 00H
( -4096 x 100 / 8192 - 0 - +4096 x 100 / 8192 cent )
Channel Coarse Tuning
mm : 10H - 40H - 70H (-48 - 0 - +48 semitones)
ll : 00H
MIDI Implementation
Pitch Bend Change
status
2nd byte
EnH
llH
n=MIDI channel number:
0H - FH (ch.1 - ch.16)
mm,ll=Pitch Bend value:
00 00H - 40 00H - 7F 7FH (-8192 - 0 - +8191)
System Realtime Messages
Active Sensing
status
FEH
* Transmitted at intervals of approximately 250ms.
* Not transmitted if the Active Sensing parameter (SYSTEM/MIDI/TRANSMIT MIDI) is
OFF.
System Exclusive Messages
There is a kind of the Universal Non-realtime messages and the Data Set (DT1) messages in
the System Exclusive messages transmitted by this device.
Universal Non-realtime System Exclusive Messages
Identity Reply Message
When Identity Request message (p. 186) is received, this message will be transmitted.
status
data byte
F0H
7EH, dev, 06H, 02H, 41H, 6AH, 00H,
04H, 00H, 00H, 01H, 00H, 00H
Byte
Remarks
F0H
Exclusive status
7EH
ID number
dev
device ID
06H
sub ID#1
02H
sub ID#2
41H
ID number
6AH 00H
Device family code
04H 00H
Device family number code
00H 01H 00H 00H
Software revision level
F7H
EOX
Data Transmission
Data Set1
DT1
status
data byte
F0H
41H, dev, 6AH, 12H, aaH, bbH,
ccH, ddH, eeH, ... ffH, sum
Byte
Remarks
F0H
Exclusive status
41H
ID number
dev
device ID
6AH
model ID
12H
command ID
aaH
address MSB
bbH
address
ccH
address
ddH
address LSB
eeH
data:
:
:
ffH
data
sum
checksum
F7H
EOX
* The amount of data transmitted at one time is fixed for the type of data, and the data will
be transmitted with the fixed starting address and size. Refer to the address and size
given in "Parameter Address Map" (p. 190).
* Large amounts of data must be divided into packets of 128 bytes or less, and transmitted
at intervals of approximately 20 ms.
* For the checksum, refer to (p. 204).
3rd byte
mmH
status
F7H
(Universal Non-realtime message)
(dev: 10H - 1FH)
(General Information)
(Identity Reply)
(Roland)
(End Of Exclusive)
status
F7H
(Roland)
(dev: 10H - 1FH)
(XP-30)
(DT1)
The actual data to be transmitted. Multi-byte
data is transmitted in the address order.
(End Of Exclusive)
189
Advertisement
Table of Contents
