Rear Panel (Connecting Your Equipment) - Roland Jupiter-Xm Reference Manual

Rear Panel
(Connecting Your Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
E
CTRL jack
F
HOLD jack
Expression pedal (EV-5)
Pedal switch (DP series)
B C
D
MIDI ports
Connect a MIDI device.
B
[L] switch
This turns the power on/off (p. 12).
C
DC-IN jack
Connect the included AC adaptor here.
* Fasten the AC adaptor cord into the cord guide on the bottom surface as
shown in the illustration.
AC Adaptor
D
MIDI (OUT/IN) ports
Used for connecting external MIDI devices and for transmission of MIDI
messages.
E
CTRL jack
Connect an expression pedal (EV-5; sold separately).
* Use only the specified expression pedal. By connecting any other expression
pedals, you risk causing malfunction and/or damage to the unit.
F
HOLD jack
Connect a pedal switch (DP series; sold separately).
G
AUX IN jack
Connect an external audio device.
Use a stereo mini plug for this connection.
G
AUX IN jack
Connect an audio device.
or
H
MIC
Electret microphone (mono)
Dynamic microphone
J
OUTPUT (BALANCED) jacks
Mixer
I
OUTPUT jacks
Monitor speaker
(Amplifier built-in)
H
MIC
[MIC GAIN] knob
Adjusts the volume of the mic input.
MIC IN jack
Connect a dynamic microphone
or electret condenser microphone
(plug-in power system) here.
* A condenser microphone (phantom
powered) cannot be used.
I
OUTPUT L/R jacks
These are output jacks for audio signals.
J
OUTPUT (BALANCED) L/R jacks
※ 入力端子の場合
These are output jacks for audio
TIP: HOT
2: HOT
RING: COLD
signals.
SLEEVE: GND
K PHONES jack
You can connect a set of headphones here.
L
USB port
USB MEMORY port
You can connect a USB flash drive here.
Connect or disconnect the USB flash drive while the JUPITER-Xm is
powered-off.
* Never turn off the power or disconnect the USB flash drive during a process,
such as while the "Executing..."
USB COMPUTER port
Use a USB cable to connect this port to a USB port of your computer.
This allows the JUPITER-Xm to operate as a USB MIDI device.
M
Ground terminal
* Connect this to an external earth or ground if necessary.
Reference Manual Ver. 1.5 and later
K
PHONES jack
M
L
USB port
USB flash drive
Pin assignment of MIC IN jack
TIP: HOT
RING: COLD
SLEEVE: GND
Pin assignment of OUTPUT (BALANCED) L/R jacks
※ 出力端子の場合
1: GND 1: GND 2: HOT
3: COLD 3: COLD
display is shown.
Headphones
Computer
※ 入力端子の場合 ※ 出力端
2: HOT 1: GND 1: GND
3: COLD 3: C
7