Mast Will Not Sequence Properly - Genie Superlift SL-5 Parts & Service Manual

Section 5 - Troubleshooting Flow Charts
Chart 1
Mast Will Not
Sequence
Properly
Be sure safety
brake is not locked
by raising and
lowering all columns
5 - 2
over-
Verify weight of load
loaded
against machine
capacity.
not over-loaded
not
Check position of load centered Center load and
for proper centering.
centered
Inspect the column
debris
channels and pulley
tracks for foreign debris.
no debris
binding
Check for cable binding
on cable pulleys.
not binding
yes
Check the roller wheels
for damage OR no
grease.
no
yes
Check each mast
column for damage.
no
Consult Genie
Industries Service
Department.
Genie Superlift
Parts and Service Manual - First Edition
Remove excess weight
from machine and
re-check.
re-check.
Clean the columns. See
Maintenance procedure
B-3, Clean the
Columns.
no
Inspect pulley and
pulley guard for
damage.
yes
Replace the pulley or
pulley guard. See
Repair procedure 2-3,
How to Replace the
Lifting Pulley - Mast
Installed.
Replace the damaged
roller wheel(s) OR apply
grease to the roller bolt.
Replace the damaged
column OR consult
Genie Industries
Service Department.
Inspect cable for
damage.
yes
Replace the cable. See
Repair procedure 2-2,
How to Replace the
Lifting Cable.
Part No. 32283