Supermicro SSE-G24-TG4 Configuration Manual page 6

Follow the steps below to configure a Physical Layer3 Interface.
Step Command
Step 1 configure terminal
Step 2 interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ....
Step 3 no switchport
ip address [<ip-address> | <ip-address>/prefix-
Step 4
length] [<subnet-mask>] [secondary]
Description
Enters the configuration mode
Enters
mode.
1.2.2
interface-type – may be any of the
following:
gigabitethernet – gi
extreme-ethernet – ex
qx-ethernet – qx
1.2.3
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the "interface range ..." command. To
provide a range use a hyphen (-)
between the start and end interface
numbers. E.g.: int range gi 0/1-10
1.2.4
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range gi 0/1-10, gi 0/20
1.2.5
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Configures the router port
Configures the IP address.
ip-address – A valid IPv4 address.
ip-address/prefix-length - A valid IPv4
Supermicro L2/L3 Switches Configuration Guide
the interface configuration
6