Supermicro SSE-G24-TG4 Configuration Manual page 32

Authentication
Pre-empt
Advertisement interval
Follow the steps below to configure VRRP.
Step Command
Step 1 configure terminal
Step 2 router vrrp
Step 3 interface [{ vlan<vlan-id (1-4069)> | <interface-
type><interface-id> }]
vrrp<vrid(1-255)> ipv4 <ucast_addr> [secondary]
Step 4
vrrp<vrid(1-255)> priority <priority(1-254)>
Step 5
Step 6 vrrp<vrid(1-255)> preempt
Step 7 vrrp<vrid(1-255)>
<password>
Step 8 vrrp<vrid(1-255)> timer <interval(1-255)secs>
end
Step 9
Step 10 show vrrp
show vrrp detail
These commands delete values or reset todefault values, as applicable:
no router vrrp
None
Disabled
1
text-authentication
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode
Enables VRRP in the switch
Specifies the interface on which VRRP is
to be configured.
Configures the virtual IPv4 address for
the specified VRRP group. This address
should be in the same subnet as the
IPv4address of the interface.
Secondary –Specifies VRRP routers to
accept the packets sent to the virtual
router's IP address
Sets the priority level used to select the
active router in a VRRP group.
The default is 100 for backups and 255
for a master that has an interface IP
address equal to the virtual IP address.
(Optional) Enables preemption.
(Optional) Assigns the simple text
authentication option and specifies the
keyname password.
range is from 1 to 255 characters. We
recommend that you use at least 16
characters. The text password is up to
eight alphanumeric characters.
(Optional) Sets the VRRP advertisement
interval time.
Exits the configuration mode.
Displays the VRRP configuration.
Displays the VRRP configuration with
additional details like advertisement
timer, authentication details, etc.
The keyname
32