Supermicro SSE-G24-TG4 Configuration Manual page 15

Defaults
Parameter
ARP request retries
ARP cache timeout
Static ARP entries
Follow the steps below to configure the ARP.
Step Command
configure terminal
Step 1
Step 2 arp timeout <seconds (30-86400)>
Step 3 arp<ip address><hardware address> {Vlan<vlan-
id(1-4069)> |
Linuxvlan<interface-name>| Cpu0}
Step 4 iparp max-retries <value (2-10)>
Step 5 end
Step 6 show iparp
show iparp summary
show iparp information
Default Value
3
300
None
<interface-type><interface-id> |
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode
(Optional)Sets the length of time, in
seconds, an Address
Protocol (ARP) cache entry stays in the
cache. The range is 30-86400 seconds.
Note: If there are frequent changes to
cache entries in a network ,a shorter
ARP timeout is recommended.
(Optional) Globally associates an IP
address with a MAC address in the ARP
cache.
ip-address—IP address in four-part
dotted decimal format corresponding
to the local data-link address.
hardware-address—Local
address (a 48-bit address).
Linuxvlan - Interface name of a Linux
VLAN interface.
Cpu0 - Out-of-band
interface
(Optional) Sets the maximum number
of ARP request retries in the range of 2-
10.
Exits the configuration mode.
Displays the ARP table entries.
Displays a summary of the ARP table,
including dynamic and static entries.
Displays the ARP configuration details.
Resolution
data-link
management
15