Grizzly G0568 Owner's Manual page 63

4.
Measure the distance "A" between the top
front face of the guide post rack and the back
of the blade (see Figure 83).
5. Measure the distance "B" between the bot-
tom front face of the guide post rack and the
back of the blade (see Figure 83).
—If the measurements taken in Steps 4–5
are equal, no adjustments need to be
made. Go to Step 9.
—If the measurements taken in Steps 4–5
are not equal, go to Step 6.
Distance "A"
(Right Side View)
Distance "B"
Figure 83. Example of measuring distance
between rack and blade at top of guide post.
6. Place the guide post guard on top of the
guide post assembly so you can access the
guide post bracket.
Model G0568/G0569 (Mfd. Since 10/11)
7. Loosen the four screws shown in Figure 82
enough to fit metal shims between the frame
and the guide post bracket (see Figure 84).
—If the guide post to blade distance is greater
at the bottom than at the top, place a shim
between the bottom of the bracket and the
frame (Shim "A"). This will tilt the bottom of
the guide post toward the blade.
—If the guide post to blade distance is less
at the bottom than at the top, place a shim
between the top of the bracket and the
frame (Shim "B"). This will tilt the bottom of
the guide post away from the blade.
Guide
Bracket
Guide
Post
Figure 84. Location for placing shims.
8. Tighten the four screws shown in Figure 82,
then repeat Steps 4–5.
—If the measurements are equal, go to Step
9.
—If the measurements are not equal, con-
tinue adding shims as needed until guide
post rack to blade distance is the same at
the top and bottom.
9.
Reinstall the guide post guard with the screws
removed in Step 3.
Shim "B"
(Left Side View)
Shim "A"
-61-